World Marketing of America QDE1425 Manuel du propriétaire télécharger pdf (Page 4)

WHAT TO EXPECT FROM YOUR COMFORT FURNACE

The Comfort Glow portable comfort furnace is not intended to replace your central heating system nor is it intended to

be a sole heating source. Your comfort furnace is intended as a supplemental zone heating source. The goal of this

heater is to reduce the total home heating costs by allowing you to turn back the central heat system and provide

supplemental heat to the rooms being occupied.

The Comfort glow portable comfort furnace is not an instant room heater. It may take 24-36 hours for your heater to

reach maximum efficiency. The portable comfort furnace will warm all the elements in the area being heated (furniture,

floors, walls etc.) This will take some time based on the size of the area, insulation ambient temperature and many

other factors but once these elements are heated they will help to maintain a more steady room temperature and less

on/off cycling of your central heat. You will notice that the comfort furnace does not rely on high speed flow of air. This

sensitive flow is by design. The purpose of the built in circulator is to move a large volume of air without creating

hot/cold spots in the area being heated, and thereby promoting a more consistent room temperature.

About your Heater:

Quartz infrared heating tubes: Provide comfortable radiant heat like the sun

Target Temperature function: Heater will operate until target temperature is reached at heaters location. Note: This

may vary from the room temperature.

Timer Function: User can program heater to turn-on or turn-off in 1-12 hours.

Eco Setting: In this mode the temperature will cycle between High/Low/Off settings to maintain a temperature at the

heater of 20 °C / 68 °F.

Cool down Cycle: fan will continue to operate for approximately 3 minutes after heating elements have turned off.

Safety Devises: See page 2

For Best Heating Results please follow these suggestions:

1) Close doors to areas you do not wish to heat.

2) Locate a three prong outlet along an interior wall if possible. Position the heater so that the warm air can blow

unobstructed across the room towards the exterior walls.

3) Check your windows and doors for the infiltration of cold air and insulate as needed to avoid heat loss. Rapid

heat loss will minimize the effectiveness of your Infrared heater as it would any conventional type heater.

4) Keep the area around the heater free of obstructions to insure maximum airflow. Keep electrical cords,

drapery, furniture, and other combustibles 3 feet (0.9 M) away from the front of the heater and away from the

sides.

5) Avoid locating your heater in high traffic areas or in direct sunlight.

6) Avoid locating your heater near your central heating thermostat.

1 2 3 4 5 6 7 8 9 ... 35 36

Pas de commentaire

World Marketing of America QDE1425 Manuel du propriétaire Page 4